
RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DS1000E, DS1000D Series
Pass/Fail
The Pass/Fail function monitors changes of signals and output pass or fail signals by
comparing the input signal that is within the pre-defined mask.
Press Utility→Pass/Fail to go to the following menu.
Figure 2- 93 Table 2- 58 The Pass/Fail menu (Page 1/2)
Turn on Pass/Fail test
Turn off Pass/Fail test
Select Pass/Fail test on CH1
Select Pass/Fail test on CH2
Pass/Fail test stopped, press to run
Pass/Fail test running, press to stop
Turn on Pass/Fail information
display
Turn off Pass/Fail information
display
Figure 2- 94 Table 2- 59 The Pass/Fail menu (Page 2/2)
Output when Fail condition
detected
Output when Pass condition
detected
Stop test when output occur
Continue test when output occur
Comentários a estes Manuais