Specications
Frequency
Specifications are valid under the following conditions: the instrument in the calibration cycle is stored at least two hours at 0°C to 50°C
temperature, and 40 minutes warm up. The specications include measurement uncertainty. Data represented in this manual are specications
unless otherwise noted.
Typical (typ.): describes characteristic performance, which 80 percent of the measurement results will meet at room temperature
(approximately 25 °C). This data is not warranted, does not include measurement uncertainty.
Nominal (nom.): indicates the expected mean or average performance, or an attribute whose performance is by design,
such as the 50Ω connector. This data is not warranted and is measured at room temperature (approximately 25 °C).
Measured (meas.): describes an attribute measured during the design phase for purposes of communicating expected performance,
such as amplitude drift vs. time. This data is not warranted and is measured at room temperature (approximately 25 °C).
NOTE: All charts represented in this manual are the measurement results of multiple instruments at room temperature unless otherwise noted.
Frequency
Frequency range
DSG3030 9kHz ~ 3GHz
DSG3060 9kHz ~ 6GHz
Frequency resolution 0.01Hz
Frequency switching speed <10ms
[1]
(typ.)
Phase offset Adjustable in 0.01° steps (nom.)
Frequency Bands
[2]
Band Frequency N
1 f ≤ 23.4375MHz 1
2 23.4375MHz < f ≤46.875MHz 0.03125
3 46.875MHz < f ≤ 93.75MHz 0.0625
4 93.75MHz < f ≤ 187.5MHz 0.125
5 187.5MHz < f ≤ 375MHz 0.25
6 375MHz < f ≤ 750MHz 0.5
7 750MHz < f ≤ 1500MHz 1
8 1500MHz < f ≤ 3000MHz 2
9 3000MHz < f ≤ 6000MHz 4
Internal Reference Frequency
Reference frequency 10MHz
Temperature stability
In temperature range 0
℃
to 50
℃
, reference to 25
℃
<
0
.
5ppm
With OCXO-A08 option < 5ppb
Aging rate
< 1ppm/year
With OCXO-A08 option < 30ppb/year
Output for internal reference
frequency
Frequency 10MHz
Level +8dBm (typ.)
Output impedance 50Ω (nom.)
Input for external reference frequency
Frequency 10MHz
Level 0dBm to +10dBm
Maximum deviation ±5ppm
Input impedance 50Ω (nom.)
NOTE:
[1] Except in the case of the band1 is switched with the other band.
[2] N is a factor used to help dene certain specications within the document.
Frequency Sweep
Operating modes
Step sweep (equally or logarithmically spaced frequency steps)
List sweep (the list of arbitrary frequency steps)
Sweep modes Single, continuous
Sweep range Full frequency range
Sweep shapes Triangle, ramp
Step change Linear or logarithmic
Number of points
Step sweep 2 to 65535
List sweep 1 to 6001
Dwell time range 20ms to 100s
Triggering Auto, trigger key, external, bus (GPIB, USB, LAN)
RIGOL
2
(152 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais