Rigol DS1000M Guia do Utilizador descarregar pdf (Página 20)

RIGOL

1-10 © Copyright RIGOL Technologies, Inc. 2007.

User’s Guide for DS1000 Series

To Use Digital Leads (Mixed Signal Oscilloscope)

1. Switch off power supply of the Device Under Test if necessary to avoid short

circuit. Since no voltage is applied to the leads at this step, you may keep the

oscilloscope on.

2. Connect one end of the flat cable FC1868 to the Logic Analyzer Input, connect

the other end to Logic Head LH1116. An identifier is located on each end of the

flat cable, it can only be connected in one way. It is unnecessary to switch off

power supply of your oscilloscope connect the cable.

Figure 1-10

CAUTION: Use only FC1868, LH1116, TC1100 and LC1150 made by

RIGOL for specified mixed signal oscilloscopes.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 167 168

Sem comentários

Rigol DS1000M Guia do Utilizador Página 20