Rigol MSO/DS1000Z Series Manual do Utilizador descarregar pdf (Página 153)

Chapter 6 MATH and Measurement RIGOL

MSO1000Z/DS1000Z User’s Guide 6-1

Auto Mode

In this mode, one or more cursors will appear. You can use auto cursor measurement

to measure any of the 33 waveform parameters. Before using this mode, you need to

at least enable one auto measurement parameter and the number of cursors will

change with the measurement parameter enabled.

Press Cursor  Mode  "Auto" and the number of cursors displayed on the screen

is determined by the measurement parameter enabled (different measurement

parameter needs different number of cursors).

Note: No cursor will be displayed if no auto cursor measurement parameter is

enabled or the measurement source has no input. When the waveform is expanded

or compressed horizontally, the cursor will move accordingly.

You can press the parameter measurement softkeys at the left of the screen to

directly switch the waveform parameter currently measured by auto cursors. If

multiple measurement parameters are turned on later, you can use Auto Item to

switch among at most five measurement parameters that are turned on last. If

"NONE" is selected, cursor measurement will not be used.

The following figure shows the auto measurement example of sine signal frequency

in CH2.

Figure 6-7 Auto Cursor Measurement

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 269 270

Sem comentários

Rigol MSO/DS1000Z Series Manual do Utilizador Página 153