Rigol DS1000Z Series Especificações descarregar pdf (Página 15)

Chapter 2 Command System RIGOL

DS1000Z Programming Guide 2-1

Chapter 2 Command System

This chapter introduces the syntax, function, parameter and using instruction of each DS1000Z command.

Main topics of this chapter:

 :AUToscale

 :CLEar

 :RUN

 :STOP

 :SINGle

 :TFORce

 :ACQuire Commands

 :CALibrate Commands

 :CHANnel<n> Commands

 :CURSor Commands

 :DISPlay Commands

 IEEE488.2 Common Commands

 :MATH Commands

 :MASK Commands

 :MEASure Commands

 :REFerence Commands

 [:SOURce[<n>]] Commands (DS1000Z-S Only)

 :SYSTem Commands

 :TIMebase Commands

 :TRIGger Commands

 :WAVeform Commands

Note:

1. Unless otherwise noted, this manual takes DS1104Z-S as an example to introduces the commands.

2. For parameter setting commands (for example, time, frequency, amplitude and etc.), the oscilloscope

can only accept numbers and set the parameters using default units and can not recognize the units

following the parameters. For the default units of each parameter, please refer to the description in

each command listed following.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 171 172

Sem comentários

Rigol DS1000Z Series Especificações Página 15