Rigol M300 Manual do Utilizador descarregar pdf (Página 82)

RIGOL Chapter 3 Commands Compatibility

Programming Guide for DM3000

3-16

Fluke Commands Compatibility

The following table lists the Fluke commands supported by RIGOL DM3000 series

digital multimeter. Before using these commands, please select the Fluke command

set using the CMDSet command (send the CMDSet FLUKE command). For more

details on this command, please refer to the “Command Set Introduction”on page 1-5.

Note: the functions of the Fluke commands in RIGOL DM3000 series digital

multimeter are listed in the “Function” column in the table below.

Fluke Command Function

AAC Enable the AC current measurement function.

ADC Enable the DC current measurement function.

VDC Enable the DC voltage measurement function.

VAC Enable the AC voltage measurement function.

CONT Enable the continuity measurement function.

DIODE Enable the diode measurement function.

FREQ Enable the frequency measurement function.

FREQ2

Enable the frequency measurement function on the secondary

display while the instrument is in AC measurement.

OHMS Enable the resistance measurement function.

WIRE2 Switch to the 2-wire resistance measurement function.

WIRE4 Switch to the 4-wire resistance measurement function.

FUNC1? Query the current main measurement function.

FUNC2?

Query the current secondary measurement function. It is only

available for AC measurement. For other measurement functions,

the query returns NULL.

CLR2

Clear the secondary function. This command is available only when

the frequency measurement function is enabled during AC

measurement.

DB Enable the DB measurement function.

DBCLR Exit the DB measurement function.

DBREF <value>

Set the DB reference value. The reference value corresponding to

the parameter is as shown in the table below. The unit of reference

resistance is dBm.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 88 89

Sem comentários

Rigol M300 Manual do Utilizador Página 82